Assume about 13,500 BTU's/hr at 25☏ glycol temps. ![]() Unit can be used for other cooling applications at higher temps if needed also. This is an indoor chiller, specifically built for a brewery with an upgraded 2 hp process glycol pump, 25☏ glycol temp range, and special piping configuration for your glycol supply/return loop to multiple tanks. Brewer in Boston purchased this 230 volt 3 phase unit and their contractor could not supply the 3 phase power cost effectively they were promised, so this unit was traded in to KIG against a new single phase power chiller (which we provide many of). Run-off videos of unit recently shipped: Video 1 Video 2 Video 3Īlternate View 1 Alternate View 2 Inside View 1 Inside View 2Īrrived at KIG in January 2018 was this NEVER USED new condition Advantage/Temptek 2 ton Brewery Chiller. This de-rating holds true for all chillers, albeit at different percentages depending on technician's opinion, as well as compressor type and quality of insulation supplied in chiller. For a brewery application running at 28☏ fluid temp, this will supply about 9,000 BTU's of cooling. ![]() So, this 1.5 hp (ton) x 12,000 BTU's = 18,000 btu's nominal, which is about how much cooling will be supplied if you run a general industrial application at about 55☏ setpoint. Note: If we set this up for 28☏ brewery/winery application, please understand that the effective cooling it will supply is about 50% of nominal. Insulation will be installed on all internal piping Photos show no insulation on internal piping. Please see the videos posted of its sister unit recently shipped out. This is an indoor chiller, designed to be in an indoor warehouse/facility environment. It can be used with water for standard manufacturing (in which case we will limit controller setpoint to 45☏), or it can be used with a 30% glycol mix for a lower temperature application like a brewery - in which case we will set it up with a 20☏ minimum setpoint. Chiller was run and tested extensively, as well as added new insulation. This 1.5 hp unit has a brand new stainless process pump installed by us, an internal reservoir, and a brazed/plate heat exchanger. Primary insulated reservoir capacity: 140 litersĪrrived at KIG in April 2016 was this Nice Advantage Air Cooled Chiller. It is not a low temperature glycol chiller, but please let us know your application details. For a non laser application we will modify and disable the smaller pump and tank (we have done this often) and you will still get the full amount of 6 tons of cooling.Ģ1.5 Kw net refrigeration capacity (about 6 tons)ĭesign Operating Temp: We typically configure these units to run and chill water/fluid in the 48☏ to 85☏ range. It has 2 compressors, a primary tank and a secondary tank, and a primary pump and a smaller secondary pump. This unit is 460 volt and originally designed to cool laser machines. A water cooled water chiller does not have fans, it uses a secondary water source (like a cooling tower) for the condenser cooling. Please let us know if you do not know the difference. ![]() This never used dual-circuit 6 ton Riedel Chiller is WATER COOLED, not air cooled.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |